Table of Contents
Advertisement
Configuration
(Slave to Slave)
AP Mode
Toggling
Reset Slave AP
(Press 3 sec) the easy configuration process also supports
"Slave to Slave" configuration.
1. Press the WEC/Reset button of the first Slave
2. Press the WEC/Reset button of the second
3. After a few seconds (normally about 30~60
Once the easy configuration process completed,
the Status LED will be recovered to its original
behavior (prior to you triggered it).
There are two alternative AP modes defined for the
device to operate with WEC (Wireless Easy
Connection) feature. One is Master Mode (by
default), and the other is Slave Mode.
To change the AP mode from one to the other, you
have to:
1. Press the WEC/Reset button for 6~10 seconds,
WEC/Reset
(Press 8 sec)
2. The WiFi LED becomes OFF in 3 ~ 5 seconds,
3. After about 20 ~ 25 seconds, the WiFi LED will
It takes about 36 seconds to change (toggle) the
AP Mode completely.
WiFi Green LED : Device is in Master Mode
WiFi Amber LED: Device is in Slave Mode
WEC/Reset
1. Press the WEC/Reset button for about 11~15
AP (say Slave1 that has been paired and
configured) for 1~3 seconds, release it to trigger
the WEC process. Then, the WiFi LED flashes
fast.
Slave AP (say Slave2 that is an un-configured
Slave AP) for 1~3 seconds, release it to trigger
the WEC process. Then, the WiFi LED flashes
fast.
seconds). The Slave1 and Slave2 APs can be
paired automatically, and auto-duplicates the
wireless setting of the Slave1 as that of the
Slave2.
(If there is something wrong during paring the
two devices, the process will be finished in 2
minutes.)
and then release it.
be lit ON again to indicate that the AP Mode is
changed.
Advertisement
Table of Contents
