Advertisement
1
3
POST-MOTOR FILTER
1
Remove the Shark
the Shark
logo knob on the post
®
motor cover.
2
Using a Philips screwdriver, remove
the wo screws from the logo knob.
3
Twist the Shark
post-motor cover counter-clockwise
to release cover.
4
Use both hands to grip the cover on
both sides and pull the cover toward
you.
5
Gently peel the filter off the inside of
the cover. Thoroughly rinse the filter
in lukewarm water. Squeeze out any
excess water. Air dry for 24 hours
before reusing.
6
Insert a dry filter into the inside of
the cover. Snap the cover onto the
Vac-Then-Steam™.
2
4
logo sticker from
®
logo knob on the
®
A replacement post-motor
filter has been provided
with your product. Use the
replacement filter while the
other is drying.
7
Twist the Shark
and replace the two screws to secure
the cover.
NOTE: Replacement logo stickers are
provided should you wish to
re-attach them.
NOTE: Using only water, thoroughly
rinse filter every 3 months and dry
for 24 hours. Replace filter in the
Vac-Then-Steam™ once a year. More
regular filter care or replacement
may be required with excessive use.
DO NOT use a hair dryer or any other
forced hot air to dry any of the filters.
NOTE: Any other servicing should be
performed by an authorized service
representative.
ORDERING REPLACEMENT PARTS
To order additional replacement parts
and accessories, feel free to contact
us at: Freephone 0800 862 0453.
www.lakeland.co.uk
logo knob clockwise
®
13
Advertisement
