Specifications - Crown PIP-EDCB Reference Manual

Crown pip-edcb input processors: reference guide
Table of Contents

Advertisement

4 Specifications

Note: All specifications are refer-
enced to a 0.775 volt input sig-
nal.
Signal to Noise: Greater than 95
dB from subsonic filter corner
frequency to 20 kHz.
Frequency Response: ±0.1 dB
from 70 Hz to 30 kHz with sub-
sonic filter corner frequency set
to 36 Hz. +0, –3 dB from sub-
sonic filter corner frequency to
30 kHz.
Harmonic Distortion (THD):
Less than 0.01% THD at 1 kHz.
Common Mode Rejection:
Greater than 65 dB at 1 kHz.
Crown Audio Division Technical Support Group
Plant 2 SW, 1718 W. Mishawaka Rd., Elkhart, Indiana 46517 U.S.A.
Phone: 800-342-6939 (North America, Puerto Rico and Virgin Islands) or 219-294-8200
Fax: 219-294-8301 Fax Back (North America only): 800-294-4094 or 219-293-9200
For Technical Support contact:
Fax Back (International): 219-294-8100
Internet: http://www.crownaudio.com
Crosstalk: Less than 0.5 mV at
20 kHz.
Connectors: 3-pin female XLR
for each input.
Input Impedance: Nominally 30
K ohms balanced. 15 K ohms
unbalanced.
Maximum Input Level: 35 VAC.
Maximum Output Level: +18
dB with 600 ohm load.
Nominal Gain: Unity ±0.5 dB.
Dimensions: 6
(16.2 x 4.8 x 9.8 cm).
3
/
x 1
7
/
x 3
7
/
in.
8
8
8

Advertisement

Table of Contents
loading

Table of Contents