Panasonic K-EW114L03AE Operation Manual page 44

IP Version It is to select IP version. IPV4 or IPV6.
You can access the IP address of these two versions.
IP Address Please use the keyboard to input the corresponding number to
modify the IP address and then set the corresponding subnet
mask and the default gateway.
Subnet mask Input subnet mask of the network
Default Gateway Input default gateway of the network
Primary DNS DNS IP address.
Sever
Secondary DNS Alternate DNS IP address.
Server
Enable You can use ARP/Ping command to modify or set the device IP
ARP/Ping to set address if you know the device MAC address.
IP address
Before the operation, please make sure the network camera
service.
and the PC in the same LAN. This function is on by default.
You can refer to the steps listed below.
Step 1: Get an IP address. Set the network camera and the PC
in the same LAN.
Step 2: Get the physical address from the label of the network
camera.
Step 3: Go to the Run interface and then input the following
commands.
Step 4: Reboot the device.
Step 5: You can see the setup is OK if you can see there are
output information such as "Reply from 192.168.0.125 ..." from
the command output lines. Now you can close the command
line.
Step 6: Open the browse and then input http://<IP address>.
Click the Enter button, you can access now.
arp –s <IP Address> <MAC>
ping –l 480 –t <IP Address>
Such as：arp -s 192.168.0.125 11-40-8c-18-10-11
ping -l 480 -t 192.168.0.125
40