Profile Management - Panasonic K-EW114L03AE Operation Manual

Mirror
Flip
DNR
DNR Level
Cancel
Default

Profile Management

4.2.3
The profile management interface is shown as in Figure 4-12.
HLC After you enabled HLC function, the device can
lower the brightness of the brightest section
according to the HLC control level. It can reduce
the area of the halo and lower the brightness of
the whole video.
The value ranges from 1 to 100. The default
value is 50 when HLC is on.
HLC is enabled only when anti-flicker is outdoor
and exposure mode is auto.
OFF It is to disable the BLC function. Please note this
function is disabled by default.
It is to switch video left and right limit.
This function is disabled by default.
It is to switch video up and bottom limit. This function is
disabled by default.
It is to switch digital noise reduction on and off.
It is to set digital noise reduction level. The value ranges from 1
to 100. The default value is 50.
It is to cancel the operation in current interface and restore
previously saved operation.
It is to set device default setup.
Figure 4-8
36