Axis P3905-RE User Manual page 57

AXIS P3905-RE Network Camera
Technical specifications
The control button is used for:
• Resetting the product to factory default settings. See page 50.
• Connecting to an AXIS Video Hosting System service. See page 42. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 43. To connect, press and hold the button for about 3 seconds.
Connectors
Network connector
The Axis product is available in two variants with different network connectors:
RJ45 Ethernet connector with Power over Ethernet (PoE).
D-coded M12 connector with Power over Ethernet (PoE).
NOTICE TICE
NO NO TICE
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network
cable (STP) may be appropriate or required. All cables connecting the product to the network and that are routed outdoors
or in demanding electrical environments shall be intended for their specific use. Make sure that the network devices are
installed in accordance with the manufacturer's instructions. For information about regulatory requirements, see the
Installation Guide available at www.axis.com
M12 Connector
Note
Below image and table are only valid for P3905–RE with M12 connector.
M12 Connector
Data Power
TX+
DC+/DC-
RX+
DC-/DC+
TX-
DC+/DC-
RX+
DC-/DC+
Performance considerations
When setting up your system, it is important to consider how various settings and situations affect the performance. Some factors
affect the amount of bandwidth (the bitrate) required, others can affect the frame rate, and some affect both. If the load on the
CPU reaches its maximum, this also affects the frame rate.
57