Gigabyte GA-990FXA-UD3 User Manual page 74

For the Marvell 88SE9172:
®
Insert the floppy disk containing the SATA RAID/AHCI driver and press <Enter>. Both of the Marvell shared
library and Marvell 91xx SATA Controller need to be installed. Below we assume that you are installing the
32-bit version. First select Marvell shared library (install first) and press <Enter>. On the next screen, press <S>
to return to the screen in Figure 5. Then select Marvell 91xx SATA Controller 32bit Driver and press <Enter>.
When both of the two drivers appear on the confirmation screen, press <Enter> to continue the driver installation.
Windows Setup
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
ENTER=Select
Step 3:
On the next screen, press <Enter> to continue the driver installation. After the driver installation, you can proceed
with the Windows XP installation.
Configuring SATA Hard Drive(s)
Marvell shared library (install first)
Marvell 91xx SATA Controller 32bit Driver
F3=Exit
Figure 5
- 74 -