Table of Contents
Advertisement
Blade Inspection
1. Turn the fuel valve OFF
(page
2. Disconnect the spark plug cap from the spark plug
3. Tilt the mower to the right side so that the fuel cap side is up. This
will help to prevent fuel leakage and hard starting due to carburetor
flooding.
4. Inspect the blade for damage, cracks, and excessive rust or
corrosion.
BLADE
BLADE BOLTS
A worn, cracked, or damaged blade can break, and
pieces of the damaged blade can become dangerous
projectiles.
Thrown objects can cause serious injury.
Inspect the blade regularly, and do not operate the mower
with a worn or damaged blade.
A dull blade can be sharpened, but a blade that is excessively worn,
bent, cracked, heavily rusted, or otherwise damaged must be
replaced.
NORMAL
WORN
BENT
If a blade is bent, take the lawn mower to an authorized Honda
servicing dealer for inspection.
3).
(page
WARNING
NORMAL
TRAILING EDGE
EXCESSIVELY WORN
TRAILING EDGE
CRACKED
Blade Mounting Bolt Inspection
Inspect the blade bolts for any signs of damage
or looseness. If they are damaged, they must
be replaced.
11).
If they appear loose, a torque wrench must be
used to accurately tighten the blade bolts to the
required torque. If you do not have a torque
wrench, take your lawn mower to an authorized
dealer to have the bolts replaced or tightened.
Use only Honda Genuine blade bolts and
special washers, since they are specifically
designed for this purpose. Replacement part
numbers are on
Blade Replacement
1. Remove the two blade bolts with a 14 mm (6 point) socket wrench.
Use a wooden block to prevent the blade from turning when
removing the bolts. Remove the blade.
SPECIAL
WASHER (2)
BLADE BOLT (2)
2. Clean dirt and grass from around the blade mounting area.
3. Install the sharpened or replacement blade using the two blade
bolts and special washers as shown below.
The blade bolts and washers are specially designed for this
application. When replacing bolts and washers, use only Honda
Genuine replacement parts.
4. Tighten the blade bolts with a torque wrench to the specified
torque. Use a wooden block to prevent the blade from turning
when tightening the bolts.
Blade bolt torque: 36 ~ 43 ft-lb (49 ~ 59 N·m)
If you do not have a torque wrench, have an authorized Honda
servicing dealer tighten the blade bolts.
If the blade bolts are not torqued properly, the blade could
loosen and be thrown from the mower.
Blades thrown from the mower could seriously hurt or kill
someone.
Ensure the blade bolts are torqued properly.
page
21.
BLADE HOLDER
BLADE
DANGER
INSPECT WASHERS
AND BOLT HEADS
FOR LOOSENESS
AND DAMAGE
9
Advertisement
Table of Contents
