Table of Contents
Advertisement
The PTZ operation is only valid in one-window mode.
Here you can control PTZ direction, speed, zoom, focus, iris, preset, tour, scan, pattern aux function, light
and wiper, rotation and etc.
Speed is to control PTZ movement speed. The value ranges from 1 to 8.The speed 8 is faster than speed
1. You can use the remote control to click the small keyboard to set.
You can click
and
The PTZ rotation supports 8 directions. If you are using direction buttons on the front panel, there are only
four directions: up/down/left/right.
In the middle of the eight direction arrows, there is a 3D intelligent positioning key. See Figure 4-40.
Please make sure your protocol supports this function and you need to use mouse to control.
Click this key, system goes back to the single screen mode. Drag the mouse in the screen to adjust
section size. The dragged zone supports 4X to 16X speeds. It can realize PTZ automatically. The smaller
zone you dragged, the higher the speed.
Name
Function
key
Zoom
Focus
Iris
In Figure 4-39, click
Figure 4-41.
of the zoom, focus and iris to zoom in/out, definition and brightness.
Figure 4-39
Figure 4-40
function
Shortcut
key
Near
│
Near
close
to open the menu, you can set preset, tour, pattern, scan and etc. See
Function
function
key
Far
Far
Open
Shortcut
key
►
│
139
Advertisement
Table of Contents
