Ptz; Ptz Settings - Techpro NVR-ELE16C-P4K User Manual

position, please right click channel 1 video window and then drag to the channel 16 video window,
release button, you can change channel 1 and channel 16 position.

Tour setup: Here you can set preview window channel display mode and interval. Please follow the
steps listed below.
From Main menu->Setting->System->Display->Tour, you can see an interface shown as in Figure 4-35.
Here you can set tour parameter.

Enable tour: Check the box here to enable tour function.The general tour supports all types of
window split mode.

Interval: Input proper interval value here. The value ranges from 1-120 seconds.

Motion tour type: System support 1/8-window tour. Please note you need to go to the main
menu->Setting->Event->Video detect->Motion detect to enable tour function.

Alarm tour type: System support 1/8-window tour. Please note you need to go to the main
menu->Setting->Event->Alarm to enable tour function.

Window split:It is to set window split mode.
Tips
On the navigation bar, click
Click Save button to save current setup.

4.7 PTZ

Note:
Before you control the PTZ, please make sure the PTZ decoder and the NVR network
connection is OK and the corresponding settings are right.

4.7.1 PTZ Settings

Cable Connection
Figure 4-35
/ to enable/disable tour.
136