Kenwood JKP210 series User Manual

before using your Kenwood Children should be supervised to
G
appliance ensure that they do not play with
G Read these instructions carefully the appliance.
and retain for future reference. G Only use the appliance for its intended
G Remove all packaging and any domestic use. Kenwood will not
labels. accept any liability if the appliance is
subject to improper use, or failure to
safety
comply with these instructions.
before plugging in
G Always use the filter and never
G Make sure your electricity supply is
overfill - boiling water may splash
the same as the one shown on the
out.
underside of your kettle.
Avoid contact with steam coming
G
out of the spout area when pouring Important - UK only
The wires in the cord are coloured
and out of the lid or spout area G
as follows:
when refilling.
Green and Yellow = Earth
G Never let the cord hang down
where a child could grab it. Blue = Neutral
Always unplug your kettle Brown = Live.
G
when not in use. G The appliance must be protected
Never put the kettle, powerbase, by a 13A approved (BS1362) fuse.
G
cord or plug in liquid. WARNING: THIS APPLIANCE
G
MUST BE EARTHED.
G Never use a damaged appliance.
Get it checked or repaired: see
Note:
'service and customer care'.
G Caution: Do not operate the kettle G For non-rewireable plugs the fuse
on an inclined surface. cover MUST be refitted when
Only use the powerbase supplied replacing the fuse. If the fuse cover
G
and keep it clean and dry. is lost then the plug must not be
Make sure the lid is secure before used until a replacement can be
G
obtained. The correct fuse cover is
switching the kettle on.
identified by colour and a
G Warning: Do not open the lid
replacement may be obtained from
while the water is boiling.
G Take care when opening the lid - your Kenwood Authorised Repairer
droplets of hot water may be (see Service).
ejected. G If a non-rewireable plug is cut off it
Make sure the kettle is switched off must be DESTROYED
G
before lifting or pouring. IMMEDIATELY. An electric shock
hazard may arise if an unwanted
G Remove the kettle from the base
non-rewireable plug is inadvertently
before filling or pouring.
inserted into a 13A socket outlet.
G Never put the kettle near or on
cooker hot plates or gas burners.
G This appliance conforms to EC
G This kettle is for boiling water only.
directive 2004/108/EC on
This appliance is not intended for
G
Electromagnetic Compatibility and
use by persons (including children)
EC regulation no. 1935/2004 of
with reduced physical, sensory or
27/10/2004 on materials intended
mental capabilities, or lack of
for contact with food.
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
before using for the first time boil-dry protection
1 Wrap any excess cord around the If you switch on with too little water,
G
bracket on the underside of the your kettle will cut out automatically.
powerbase . Switch off, remove from the
2 Fill to 'MAX', boil, then pour the powerbase and let it cool down
water away. Repeat 2 to 3 times. before re-filling. When it has cooled
down, the switch will reset itself.
key
care and cleaning
flip top lid
lid release button
Before cleaning, unplug your kettle
G
on/off switch with indicator light
and let it cool down.
360° powerbase
the outside and powerbase
cord wrap
G Wipe with a damp cloth, then dry.
water level windows
Do not use abrasives - they will
filter
scratch the plastic surfaces.
to use your kettle
the inside
Even though your kettle comes with
G
1 Fill the kettle through either the
a filter, you still need to clean the
spout or lid. To open the lid, press
inside (and the filter) regularly.
the lid release button. The water
the filter
level must be between 'MAX' and
1 Open the lid. Press the lid release
1 cup (250mls).
button
Be economical: do not boil more
G
2 Gently lift out the filter
water than you need.
3 either rinse under the tap or use a
G To improve the quality of your
soft brush.
drinks always use fresh water.
or when descaling your kettle, drop
G Empty the kettle after each use.
the filter in too. Rinse thoroughly.
2 Check the lid is closed.
4 To re-fit the filter, slide it in until
3 Plug in and switch on. The indicator
secure
light will come on.
5 Close and lock the lid by pressing
4 Your kettle will boil and switch off
the lid down
automatically. To re-boil, wait a few
descaling
seconds - the on/off switch needs
time to reset.
G Regular descaling of the flat
G If you experience problems
element will improve the
with your kettle switching on
performance of your kettle. If the
and off during use or
kettle is not descaled regularly the
switching off before boiling,
build up of limescale may result in
check that the flat element is
the following:
free from scale - see
G problems may be experienced
"descaling".
with the kettle switching on and
G Your kettle is fitted with a filter to
off during use or switching off
hold back limescale particles.
before boiling.
G If you find drops of water under
the kettle may take longer to boil.
G
your kettle, don't worry - it is just
the flat element may be
G
condensation.
damaged.
Please note: Failure to descale your
kettle may invalidate your guarantee.
.
.
.
.