Docomo PRIME series N-01A Instruction Manual page 72

4 Enter a number (prefix)
You can enter up to 10 digits.
Prefix setting screen (p.69)/IDD
Prefix setting screen (p.64)
Edit, Delete this/Delete*, Delete
*: "Delete" appears on the IDD Prefix setting screen.
Making a call with a prefix number
You can add prefix numbers on the "Enter phone
number" screen and the detail screen of
"Phonebook", "Received calls", "Dialed calls" or
"Redial".
<Example: To make a voice call by adding a prefix
number on the enter phone number screen>
Enter the phone number of the
1
other party
u (FUNC) "Prefix numbers"
2
Select a stored name r
Setting Sub-Address When
Making a Call
Set whether to specify "*" in the phone number as a
separator so that the digits following "*" are
recognized as a sub-address (ON or OFF).
Sub-addresses are used in ISDN to identify calls
made from specific communications devices and to
select content in "V-live".
i "Settings/Service"
1
"Dialing" "Sub-address setting"
"ON" or "OFF"
N
In the following cases, "*" does not function as a
sub-address separator. The number including "*"
is recognized as an ordinary phone number.
• When "*" is entered at the beginning of a phone
number
• When "*" immediately follows "186" or "184" at
the beginning of a phone number
• When "*" immediately follows a number
entered using "Prefix numbers"
• When the phone number contains "*590#",
"*591#" or "*592#"
70
all......Select an option.
<Prefix numbers>
<Sub-address setting>
Setting the Alarm for
Reconnection
When the signal quality deteriorates during a voice/
videophone call or PushTalk communication and the
call disconnects, the FOMA terminal will
automatically reconnect the call if the signal quality
quickly improves. Set the type of alarm when a call is
reconnected.
The time required for reconnection varies
depending on communication conditions or the
signal quality. It takes about 10 seconds.
i "Settings/Service" "Talk"
1
"Reconnect signal" Select an
alarm tone
Select "No tone", "High tone" or "Low tone".
N
Call charges also apply until reconnected (up to
about 10 seconds).
Making the Earpiece Sounds
Clear
This function detects ambient noise and makes the
other party's voice clear during a voice or videophone
call.
When handsfree is on or an external device such
as flat-plug earphone/microphone with switch
(optional) is connected, this function is disabled.
In-call screen (p.58)
1
p (
/
Pressing p switches the setting in the
following order: "High"
High......Activate the function even when quiet,
regardless of the ambient noise.
Low......Activate the function only when the ambient
noise is high.
OFF......Deactivate the function.
■ To set from the main menu
i "Settings/Service" "Talk" "Hyper Clear
Voice" "High", "Low" or "OFF"
N
This function changes the sound quality or
volume. Change the setting if necessary.
<Reconnect signal>
<Hyper Clear Voice>
/ )
→ "OFF" → "Low".