AEG SCT81800S0 User Manual page 15

Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.
Upper or lower
square is shown in
the temperature Dis-
play.
dEMo appears on
the Display.
Possible cause
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The temperature regula-
tor is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
The temperature regula-
tor is not set correctly.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (dEMo).
ENGLISH
Solution
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Set a higher/lower temper-
ature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Store less products at the
same time.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the
door".
Set a higher temperature.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start
works regularly.
15