Fresh Water System; Kitchen Sink; Bath Sink, Shower & Accessories; Monitor Panel - NewMar 2006 Mountain Aire Diesel Pusher User Manual

FRESH WATER SYSTEM

Kitchen Sink

The kitchen sink installed in your unit may be an acrylic, double-bowl
sink equipped with two sink covers to provide additional counter space
when the sink is not in use. Cleaning care consists of washing with mild
detergents and a soft cloth. Avoid using "S.O.S." type cleaning pads
because they may scratch the surface. The faucet in the kitchen may be
a single-handle faucet with a pullout spout.
Bath Sink, Shower & Accessories
The sink in the bathroom may be a porcelain sink. Use care when
cleaning to prevent from scratching the surface. The bathroom
accessories include two towel bars and a tissue holder. The faucet in
the bathroom consists of a metal body with a brass finish. The shower
installed is a combination fiberglass tub/shower with a glass shower
door. The white tub faucet with shower head, hose and bracket
coordinate with the sink faucet. An optional assist handle may be
installed in the tub/shower.

Monitor Panel

The monitor panel allows you to check the approximate levels in the
fresh, gray, and black water holding tanks, as well as the battery
condition. The monitor panel is generally located above or near the
entrance door. Simply press the button of the item to check its status.
The empty indicator light will always light when the button is pressed.
If the tank is full, all of the lights will be on. Lights are sequential and
indicate the level in approximately 1/4 tank increments. For example:
If the tank selected is approximately 1/2-full, then the indicator lights E,
1/4, and 1/2 will be lit. On the right hand side of the monitor panel is the
water pump switch. This switch controls the power going to the water
pump, turning it either on or off.

Monitor Panel Calibration

The monitor panel comes to you factory calibrated for accuracy and
should not need to be adjusted. In the event that the system does not
read accurately, then re-calibration may be necessary. The procedure
for re-calibration is simple: First, fill the tank to be re-calibrated.
Second, using the adjustment tool enclosed in the Owner's Package (or
any small flat-bladed screw driver), simultaneously push the button for
7:3
2006 Mountain Aire Diesel Pusher by Newmar