Fresh Water System; Fresh Water Tank - NewMar ventana 2017 Owner's Manual

Table of Contents

Advertisement

When replacing the filter, make sure the rubber O-Ring seal is properly positioned in its groove in the cartridge
housing. An improperly positioned or missing seal will cause leakage around the perimeter of the filter
housing.
4. Reattach the canister to the filter housing by rotating the canister in a counter clockwise direction. Do not
overtighten the canister when attaching it back to the housing.
Do not allow water to freeze in the water filter canister. Freezing will crack and permanently damage the filter
housing and associated plumbing. Always remove the filter cartridge prior to winterization.
For More Information
Refer to the product manufacturer's owner's manual and links to learn more about your coach's filters.

Fresh Water System

The Fresh Water System consists of the fresh water holding tank, water pump, valves, connection hoses, and fresh water
plumbing lines. This system is responsible for providing potable water for drinking, cooking, bathing, and all other activities
that require clean water. The capacity of your fresh water tank may vary, depending on the coach model and year.
These brief operation instructions are for quick reference only. Any quick start instructions provided should
not take the place of the complete Operation Manual provided by this item's manufacturer.

Fresh Water Tank

All of the water should be drained from the fresh water system when the unit is not in use for more than one week.
Whenever possible, drain the fresh water tank before traveling or only carry what you will need to get to your destination.
Water in the tank will reduce the carrying capacity of the unit.
© 2016 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
This tank is used to hold fresh potable water for use
throughout the water system. The fresh water tank is filled
from the city water hook-up. The valve located in the service
compartment near the water hook-up determines whether the
city water is going through the water system or into the fresh
water tank. The excess water will be vented from an overflow
vent pipe onto the ground when the tank capacity has been
reached. This pipe is installed in the fresh water tank to
prevent tank rupture from overfilling.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents