Manual Extension And Retraction; Shaft End-Mounted Motors - NewMar 2006 Mountain Aire Diesel Pusher User Manual

To extend the room, press and hold the slide out button. The voice modulator
will activate and say, "Your lock arms are unlocking. Please be certain all
seats, chairs, and other obstacles clear of the slide out area". The power lock
arms will retract into their housings, and the room will begin to extend
approximately 10 seconds after the voice begins. It will continue to run until it
reaches the end of its travel, or until you release the slide out switch.
To retract the room, press the slide out button as described above, holding it
for the duration of room travel. The room will retract, and at the end of its
travel the slide out motor will stop, and the Power Locking Arms will deploy,
securing the room to the sidewall of the unit. Please note that you must hold
the slide out button down during this entire cycle.
The power locks require a minimum of 9 volts DC to operate. In the event of
a loss of power, or if the voltage dips below the minimum requirements, the
locks will not extend or retract automatically. For proper operation of the room
and locks battery voltage must be maintained above the minimum
requirements. Also please note that there is a safety "lock out" system
incorporated in the slide out electronics that prevents the room from operating
when the ignition key is "on". The automatic locking arms require no
maintenance, and should be serviced as necessary only by a qualified
technician.

MANUAL EXTENSION AND RETRACTION

Shaft end-mounted motors

If the motor is mounted on the ends of the slide out shaft, use the following
directions:
1.
Access must be gained to the TRANS-TORQUE bushing coupling at the
end of the slide out gear motor.
2.
Using a 1/2" drive – 11/2" open end
wrench and a 1/2" drive ratchet
wrench, loosen the 11/2" nut. This will
require approximately 11/2 turns. The
nut is a standard right hand thread.
After the initial release, the nut will
turn for a partial turn, and then will
release again as you turn the wrench.
This second release is required to
2006 Mountain Aire Diesel Pusher by Newmar
8:5