Advertisement
2
3
1
– 17 –
STEERING CABLE
1. Check:
Distance a, b
Out of specification → Adjust.
Difference of distances a and b:
Maximum 5 mm (0.2 in)
Checking steps:
Turn the handlebar lock to lock.
Measure the distances a and b.
If the difference of distances a and b
is not within specification, adjust the
cable joint.
2. Adjust:
Steering cable joint (handle side)
Adjustment steps:
Loosen the locknut 1.
Disconnect the cable joint 2 from the
ball joint 3.
Turn the cable joint in or out for
adjusting the distances a and b.
Distance a is increased.
Turn in
Distance b is increased.
Turn out
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
Connect the cable joint and tighten the
locknut.
Locknut:
6 Nm (0.6 kgf • m, 4.3 lb • ft)
E
Advertisement
