Advertisement
1. Fill:
Battery electrolyte
Filling steps:
Remove all the filler caps using pliers.
Fill with the specified electrolyte from
a jug.
After the electrolyte is filled up as far as
the UPPER LEVEL a, allow the cell to
stand for 20 minutes. If after 20 min-
utes, the electrolyte level has dropped,
add more electrolyte up to the UPPER
LEVEL mark once again.
2. Inspect:
Battery fluid specific gravity
Out of specification → Charge.
Specific gravity at 20˚C (68˚F):
1.28
Charging current:
68.4 kC (1.9 Amps × 10 Hrs)
3. Install:
Filler caps
CAUTION:
Rinse off any electrolyte from the battery
case and wipe the battery dry prior to
installation.
– 14 –
E
Advertisement
