Power Output - Crown I-Tech I-T4000 Brochure

The features you want.
Channel Indicators
For each channel, a column of LEDs
indicate a full range of amplifier diag-
nostics and information, including Fault,
Thermal, Ready, Clip, Signal Presence
and Signal Level.
AC Mains
Circuit Breaker
Offers extra protection
for the amplifier.
Patented Class-I switching output
Lightweight 2U package
Power Factor Correction (PFC)
Direct digital audio inputs
Integrated networking
Intelligent LCD Screen and Controls
Lets you adjust the amplifier's attenuation
and muting, configure the amp, recall DSP
presets, and set up and view error monitor-
ing. The presets allow you to quickly recon-
figure the amp for various applications.
Analog Inputs Section
• Balanced Analog
XLR Inputs.
• Balanced Analog XLR
Daisy-chain Outputs.
• Input Ground Lift Switch.
• Highest output voltage available
• Global regulated power supply
• Studio-grade DSP inside
• 24-bit / 96-kHz converters
• Intuitive LCD display
Rugged chassis design

POWER OUTPUT

STEREO
8 Ohm 4 Ohm
I-T8000 2100 W 4000 W
I-T6000 1500 W 3000 W
I-T4000 1250 W 2000 W
Guaranteed minimum power output per channel, 20Hz to 20 kHz, <0.35% true THD, both
channels driven. Rated power not part-tolerance dependent.
Digital Inputs Section Networking Section
• AES/EBU Digital Input Accepts a connector from
XLR Connector. a TCP/IQ network cable.
• Active Link/Out • LINK ACT indicator
Connector. shows network activity.
• 100 Mb indicator shows
a 100 Mb network
connection.
• Preset indicator blinks
to indicate active preset;
count flashes to
determine number.
• IQ Data LED shows
IQ link activity.
MONO
2 Ohm 8 Ohm 4 Ohm
3500 W 8000 W 7000 W
2500 W 6000 W 5000 W
1800 W 4000 W 3600 W
The power you need.
Power Switch
Indicators
Glows green when
Power, Data
AC power is present
and Bridge
at the power cord.
Mode.
Outputs Section
• 4-Pole Speakon
Output Connectors:
Accept 2-pole or
4-pole Speakon
connectors.
• 5-Way Binding Post
Output Jacks: Accept
banana plugs, spade
lugs or bare wire.
®