Table of Contents
Advertisement
Cutting Rotary Clutch Lever: [ON]
Back Plate
Lining
Less than 5mm
Groove for Lining
5335M-0508-020E
Turn Buckle
5335M-0508-030E
Cutting Rotary Clutch Lever: [OFF]
Turn Buckle
Groove for Lining
5335M-0508-010E
Inspecting the Blade Brake
1.
Start engine.
2.
Turn throttle lever to [
3.
Set cutting height to the highest (120mm).
4.
Move cutting rotary clutch lever to [ON] to rotate cutting blade.
Maintenance
6.
Make sure brake lining is not touching groove
on pulley for lining. Also make sure the gap
Lining
between the edge of pulley and lining back
plate to be less than 5mm.
7.
Adjust turn buckle if lining is touching groove
or back plate and the edge of pulley is more
than 5mm.
8.
Turn cutting rotary clutch lever to [OFF].
9.
Make sure lining is firmly in contact with
groove on pulley.
10. Jiggle turn buckle to make sure it has a little
Lining
play.
11. If lining is not firmly in contact with pulley or
turn buckle is too tight ti jiggle, re-adjust.
12. Turn cutting rotary clutch lever to [ON] and
[OFF] about 5 times and repeat the checks 4
and the following. Re-adjust if necessary.
13. Install engine hood, rear bumper, and lower
rear cover.
(fast)] to raise engine speed.
-69-
5
Advertisement
Table of Contents
