Service Call Check; Before Operation - Sharp R-15AT Original Instruction

Commercial microwave oven 1000w(iec 60705)
Hide thumbs Also See for R-15AT:
Table of Contents

Advertisement

SERVICE CALL CHECK

Please check the following before calling for service.
1. Power Supply
Check the power plug is properly connected to a suitable wall outlet.
Check the line fuse/circuit breaker is functioning properly.
2. When the door is opened:
Does the oven lamp light?
3. Place one cup of 150 ml water in the oven and close the door securely.
Touch these keys.
A. Does the oven lamp come on?
B. Does the ventilation work?
(Place your hand over the ventilation openings and check for air flow.)
C. After 1 minute does the signal sound?
D. Does the cook indicator go off?
E. At the end of this time, is the water warm?
If "NO" is the answer to any of the above questions, call your dealer or an authorized SHARP Service Agent and
report the results of your check.

BEFORE OPERATION

The operation of the oven is controlled by pressing the appropriate pads on the control panel.
A signal should be heard each time you press the control panel.
When you first connect the microwave oven to an
electrical socket, the digital display will show
.
Key pad entries can only be made when the door
is closed.
SOUND SETTING
There is a choice of 2 different sounds or no
sound on your oven.
STOPPING THE OVEN
If you want to stop the oven during cooking, press
the STOP/CLEAR key
door (except memory cooking).
To start the oven again, close the door and press
the START key
once or open the
within 1 minute.
The programme or check mode is cancelled when
any keys are not pressed for more than 3 min-
utes.
will appear on the display after the time
reaches zero. It will disappear when the oven door
is opened or the STOP/CLEAR key
pressed.
To set a signal, touch the SET key
within 2 seconds and then touch the SIGNAL key
continuously until you hear the tone re-
quired.
If you open the door during memory cooking, the
programme is cancelled.
If you want to cancel a programme during cook-
ing, press the STOP/CLEAR key
If you want to clear a mistake during program-
ming, press the STOP/CLEAR key
4
YES ____ NO _____
YES ____ NO _____
YES ____ NO _____
YES ____ NO _____
YES ____ NO _____
YES ____ NO _____
twice
twice.
once.
is

Advertisement

Table of Contents
loading

Table of Contents