Beko WI1483 User Manual page 36

Troubleshooting
Problem
washing takes longer
time than specified in the
manual.(*)
Programme time does not
countdown. (On models
with display) (*)
Programme time does not
countdown. (*)
Machine does not switch
to spinning step. (*)
36 / EN
Reason
Water pressure is low.
Voltage might be low.
Input temperature of water might be low.
Number of rinses and/or amount of rinse
water might have increased.
Excessive foam might have occurred and
automatic foam absorption system might have
been activated due to too much detergent
usage.
Timer may stop during water intake.
Timer may stop during heating step.
Timer may stop during spinning step.
There might be unbalanced load in the
machine.
There might be unbalanced load in the
machine.
The machine will not spin if water is not
drained completely.
Excessive foam might have occurred and
automatic foam absorption system might have
been activated due to too much detergent
usage.
Solution
Š Machine waits until taking in adequate
amount of water to prevent poor washing
quality due to the decreased amount
of water. Therefore, the washing time
extends.
Š Washing time is prolonged to avoid poor
washing results when the supply voltage
is low.
Š Required time to heat up the water
extends in cold seasons. Also, washing
time can be lengthened to avoid poor
washing results.
Š Machine increases the amount of rinse
water when good rinsing is needed and
adds an extra rinsing step if necessary.
Š Use recommended amount of detergent.
Š Timer indicator will not countdown until
the machine takes in adequate amount of
water. The machine will wait until there is
sufficient amount of water to avoid poor
washing results due to lack of water. Timer
indicator will resume countdown after this.
Š Timer indicator will not countdown
until the machine reaches the selected
temperature.
Š Automatic unbalanced load detection
system might be activated due to the
unbalanced distribution of the laundry in
the drum.
Š Automatic unbalanced load detection
system might be activated due to the
unbalanced distribution of the laundry in
the drum.
Š Automatic unbalanced load detection
system might be activated due to the
unbalanced distribution of the laundry in
the drum.
Š Check the filter and the draining hose.
Š Use recommended amount of detergent.
Washing Machine /User's Manual