Adjusting The Feet; Electrical Connection - Beko WI1483 User Manual

Table of Contents

Advertisement

Installation
• To prevent flowing of dirty water back into the
machine and to allow for easy discharge, do not
immerse the hose end into the dirty water or do
not drive it in the drain more than 15 cm. If it is
too long, cut it short.
• The end of the hose should not be bent, it
should not be stepped on and the hose must
not be pinched between the drain and the
machine.
• If the length of the hose is too short, use it by
adding an original extension hose. Length of the
hose may not be longer than 3.2 m. To avoid
water leak failures, the connection between
the extension hose and the drain hose of the
product must be fitted well with an appropriate
clamp as not to come off and leak.

3.6 Adjusting the feet

A
wARNiNg:
product operates more silently and vibration-
free, it must stand level and balanced on its
feet. Balance the machine by adjusting the
feet. Otherwise, the product may move from
its place and cause crushing and vibration
problems.
1. Loosen the lock nuts on the feet by hand.
Washing Machine /User's Manual
In order to ensure that the
2. Adjust the feet until the product stands level
and balanced.
3. Tighten all lock nuts again by hand.
A
wARNiNg:
the lock nuts. Otherwise, they will get
damaged.

3.7 Electrical connection

Connect the product to a grounded outlet
protected by a 13 A fuse. Our company shall not
be liable for any damages that will arise when the
product is used without grounding in accordance
with the local regulations.
• Connection must comply with national
regulations.
• Power cable plug must be within easy reach
after installation.
• If the current value of the fuse or breaker in the
house is less than 13 Amps, have a qualified
electrician install a 13 Amp fuse.
• The voltage specified in the "Technical
specifications" section must be equal to your
mains voltage.
• Do not make connections via extension cables
or multi-plugs.
B
wARNiNg:
be replaced by the Authorised Service
Agents.
Do not use any tools to loosen
Damaged power cables must
13 / EN

Advertisement

Table of Contents
loading

Table of Contents