Primary Harness (H1) Wire Connection Guide; Secondary Harness (H2) Wire Connection Guide - Directed Electronics Python 1500 esp Installation Manual

secondary harness (H2) wire connection guide

H2/1 GRAY/BLACK (-) diesel wait-to-start bulb input
Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash-
board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK wire can be directly
connected to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must
be used to change the polarity. Here are some common colors of this wire:
I Chevrolet and GMC trucks - Light blue or dark blue
I Ford Trucks - Black/pink
I Dodge Ram Trucks - Orange/black or black/orange
NOTE! A 1-amp diode must be installed in line on the factory wire between the wait-to-start indi-
cator and the ECM. (See the following diagram for details.)
© 2000 Directed Electronics, Inc. Vista, CA
13