Table of Contents
Advertisement
Using the clock, kitchen timer and convenience outlet.
Make sure the clock is set to the
correct time of day.
The Kitchen Timer is a minute timer only.
The Kitchen Timer does not control
oven operations. The maximum
setting on the Kitchen Timer is 9 hours
and 59 minutes.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
To Set the Kitchen Timer
Touch the TIMER pad.
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch 2, 4
and 5 in that order. If you make a
mistake touch the TIMER pad and
begin again.
Touch the START pad.
After touching the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
To Reset the Kitchen Timer
If the display is still showing the time
remaining, you may change it by
touching the TIMER pad, then touch the
number pads until the time you want
appears in the display.
To Cancel the Kitchen Timer
Touch the TIMER pad twice.
Convenience Outlet
(on some models)
The 120V convenience outlet located on
the top of the backguard may be used to
plug in small electrical appliances.
When using the outlet, be sure that the
electrical cord does not rest on or near a
surface unit. If the surface unit is turned
on, the cord will be damaged.
www.GEAppliances.ca
Touch the CLOCK pad.
Touch the number pads.
Touch the START pad.
When the Kitchen Timer reaches :00,
the control will beep 3 times followed
by one beep every 6 seconds until
the TIMER pad is touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the TIMER pad and then
touching the number pads to enter the
new time you want.
To reset the circuit breaker, press the
switch located near the outlet on top of
the backguard.
11
Advertisement
Table of Contents
