Table of Contents
Advertisement
Select the Self Clean Function
3
The display will show
P
The
will flash.
Adjust the cycle time (optional)
4
You may set the time between 1-1/2 hours (P1:30 and 3 hours (P3:00). For heavy soiling use
a longer time.
Press the
Use the
After a few seconds the
to confirm and the
Start the cycle
5
Press the Start
The oven will come on and the
After a few seconds the door will lock and the door lock indicator light will come on.
The display will start to count down.
Note: If the door is not shut completely, after a few minutes the oven will switch off, the display
will show 'Fdor' and the oven will beep. See 'Troubleshooting' .
At the end of the Self Clean cycle
6
The oven will turn off.
The display will show
Turn the function dial to O (Off ).
7
The door will remain locked.
The door lock indicator will remain on.
The display will show 'hot' .
When the oven has cooled to a safe temperature, the door lock indicator will go out and the
door will unlock. The display will show the time of day. This may take 30 minutes.
Note: The oven will still be very warm. To avoid burns, wait for the oven to cool completely
before wiping out the ash and replacing side racks and shelves.
To cancel a Self Clean cycle
Turn the function dial to O (Off ).
Note: The oven door will remain locked until the oven has cooled to a safe temperature. The door
lock indicator light will remain on, and the display will show 'hot' .
P1:30
P
button - the
will go out.
and
buttons to change the time.
P
will start to flash again. Alternatively, press the Start
P
will flash.
P
button. The
P:00
and a flashing A
Using the Self Clean function
A
will stop flashing.
indicator will show in the display.
55
button
Advertisement
Table of Contents
