Reset To Factory Defaults - Technicolor TG582n Setup And User Manual

10 SUPPORT

10.5 Reset to Factory Defaults

Resetting your Technicolor Gateway
If at some point you can no longer connect to the Technicolor Gateway or you want to make a fresh install, it may be useful
to perform a reset to factory defaults.
Warning
A reset to factory default settings deletes all configuration changes you made. Therefore, after the reset a reconfiguration of
your Technicolor Gateway will be needed.
Also your wireless clients will have to be re-associated, as described in
page 35.
Methods
You can choose between:
Resetting the Technicolor Gateway via the Technicolor Gateway GUI

Reset the Technicolor Gateway via the Reset button

Resetting the Technicolor Gateway via the Technicolor Gateway GUI
Proceed as follows:
1 Browse to the Technicolor Gateway
2 On the Technicolor Gateway menu, click Configuration.
3 In the Pick a task list, click Reset my Technicolor Gateway.
4 The Technicolor Gateway restores the initial configuration and restarts.
5 The Technicolor Gateway returns to the Technicolor Gateway home page (unless the IP address of your computer is not
in the same subnet as the default IP address of the Technicolor Gateway, being 192.168.1.254).
Reset the Technicolor Gateway via the Reset button
Proceed as follows:
1 Make sure the Technicolor Gateway is turned on.
2 Push the Reset button for 7 seconds and the release it.
84
GUI.
"5 The Technicolor Gateway Wireless Access Point" on
DMS-CTC-20101206-0009 v1.0