Securing Your Wireless Connection - Technicolor TG582n Setup And User Manual

5.3 Securing Your Wireless Connection

Introduction
You can protect the wireless communication between the wireless clients and your Technicolor Gateway with a wireless key.
This means that:
Only clients which use the correct Network Name (SSID) and wireless key can connect to your network.

All data passing through your wireless access point is secured and encrypted.

Encryption types
Over the years a number of encryption types have been developed. The list below gives you an overview of the supported
encryption types ordered by descending security level; you will find the highest level of security at the top of the list:
WPA-PSK Encryption:

The wireless connection is secured with a pre-shared key that has been defined by the user. Wireless clients must be
configured with this key before they can connect to the Technicolor Gateway. The Technicolor Gateway supports the
following WPA versions (ordered by descending security):
 WPA2:
The most recent and most secure version of WPA. Choose this version if you are sure that all your wireless clients
support WPA2.
 WPA+WPA2:
This is a mixed mode. In this mode WPA2, is the preferred encryption type but wireless clients do not support WPA2,
can still use WPA as encryption type. Choose this option if not all of your wireless clients support WPA2 or if you are
not sure. Wireless clients that support WPA2 will use WPA2, the others will use WPA.
 WPA:
The first version of WPA. Choose this option if you are sure that none of your wireless clients support WPA2.
If you want to configure WPA2 on the built-in wireless utility of Windows XP Service Pack 2 (SP2), you first have
to:
Upgrade your Windows XP to Service Pack 3.

- or -
Install the following update: http://support.microsoft.com/kb/917021.

WEP Encryption:

The least safe encryption type used for wireless connections. Like WPA-PSK it uses a user-defined key, but WEP has
been proven to have security issues.
Although the Technicolor Gateway allows you to use WEP or no security, we strongly advise against using one of
them! Use WPA(2)-PSK instead.
Configuration
Proceed as follows:
1 Open the Technicolor Gateway
2 Under Home Network, click Wireless.
3 The Wireless Access Point page appears. In the upper-right corner, click Configure.
4 Under Encryption, select Use WPA-PSK Encryption.
5 In the WPA-PSK Encryption Key box, type a the key of your choice. The key must be in one of the following formats:
 8 to 63 alphanumeric characters. For example: MyKey123
 8 to 64 hexadecimal characters (characters from 0 to 9 and from A to F). For example: C54F48A5.
DMS-CTC-20101206-0009 v1.0
5 THE TECHNICOLOR GATEWAY WIRELESS ACCESS POINT
GUI.
39