Setting Up A Wired Connection - Technicolor TG582n Setup And User Manual

3.3.2 Setting up a Wired Connection

Requirements
Both your network device (for example, a computer, a gaming console,...) and Technicolor Gateway must have a free

Ethernet port.
Your network device must be configured to obtain an IP address automatically. This is the default setting.

Ethernet cable
In your package, you will find a cable with yellow connectors. This is the Ethernet cable.
Procedure
Proceed as follows:
1 Connect one end of the Ethernet cable to one of the yellow Ethernet ports of your Technicolor Gateway:
2 Connect the other end of the Ethernet cable to your network device.
The Technicolor Gateway does not support Power over Ethernet (PoE). All network devices that are connected
to the Technicolor Gateway must be powered by their own power source.
3 Your network device is now connected to your network. No additional configuration is needed unless specified by your
service provider.
DMS-CTC-20101206-0009 v1.0
3 MANUAL INSTALLATION
21