Table of Contents
Advertisement
7
Troubleshooting
Programme cannot be started or selected.
button for 3 seconds to reset the machine to factory settings. (See "Cancelling the
programme")
Water in the machine.
machine.
There is water leaking from the bottom of the washing machine.
inlet hoses are securely fitted. Attach the hose to the tap tightly.
completely closed.
Machine does not fill with water.
Machine does not drain water.
Machine vibrates or makes noise.
filter.
safety bolts.
machine.
from the machine or distribute the load by hand to balance it homogenously in the
machine.
leaning on anything.
Machine stopped shortly after the programme started.
running when the voltage restores to the normal level.
Machine directly discharges the water it takes in.
hose as described in the operation manual.
No water can be seen in the machine during washing.
The water level is not visible from outside of the washing machine. This is not a
failure.
Press and hold Start / Pause / Cancel
This is not a failure; water is not harmful to the
Open the inlet water taps fully.
Flatten the water inlet hose.
Clean the water inlet filter.
Close the Loading Door.
Clean the pump filter.
Be sure the seals of the water
Make sure that the pump filter is
Clean or flatten the hose.
Adjust the feet to level the machine.
Remove the transportation
Add more laundry to the
Take out some of the laundry
Make sure that the machine is not
Connect the water draining
EN
Clean the pump
It will resume
Hide quick links:
Advertisement
Table of Contents
