Frequent Misfeeds - Xerox DocuPrint 92C NPS Troubleshooting Manual

Frequent misfeeds

XEROX DOCUPRINT 92C NPS TROUBLESHOOTING GUIDE
Frequent misfeeds may be caused by a glazed feed belt, especially
if one tray feeds the same kind of paper better than another tray
does. (Glazing is caused by a buildup of the chemicals found on most
papers.)
If you suspect that the belt is glazed, try cleaning it with film remover
obtained from your service representative.
Caution: Clean the feed belt only to correct misfeeds, not as
routine maintenance. Because the belt is rubber, frequent cleaning
dries it out and makes it fail prematurely.are or software.
1. Clear any misfeeds that have occurred, but do not latch the
paper feeder assembly. If necessary, unlatch it by pressing
down on the bright green lever on the right side of the paper
tray.
2. Lightly moisten a lint-free towel with film remover and
thoroughly wipe the outside surface of the feed belt in the same
direction as the ribs on the belt. (Wiping from side to side might
pull the belt off its track.) Allow a few seconds for the film
remover to evaporate.
CLEARING PAPER MISFEEDS AND JAMS
4-3