Bosch HMV 8051 U Installation Instructions Manual page 14

Attaching the mounting plate
(Wall stud at one corner hole)
Attaching the mounting plate
(Wall studs at both corner holes)
,41
_J
5. Check if the plate is properly centered, make sure it is level.
6. Securely tighten all screws, including the fifth wood screw in the bottom area of
the mounting plate.
1. Insert the bolts and the wood screws into the mounting plate through the holes
designated.
2. Attach toggle wings from the back of the mounting plate onto each bolt. Leave
enough space for toggle wings to go through the wall and to open.
3. Place the mounting plate against the wall and make sure tabs are touching the
bottom of the cabinet or the level line (see "Aligning the mounting plate").
4. Push the bolts through the drywall and finger tighten the bolts to make sure
toggle wings have opened against drywall.
5. Check if the plate is properly centered, make sure it is level.
6. Securely tighten all screws and bolts.
1. Insert the wood screws into the mounting plate through the holes designated.
2. Place the mounting plate against the wall and make sure tabs are touching the
bottom of the cabinet or the level line (see "Aligning the mounting plate").
3. Check if the plate is properly centered, make sure it is level.
4. Securely tighten all screws.
15