Edit Preferences - Crestron SIMPL+ Reference Manual

Crestron SIMPL+
Language Reference Guide - DOC. 5797G
®
NOTE: In previous versions of SIMPL+, the settings for the target types were
system-wide. Those settings applied to all SIMPL+ modules that were opened and not
specific to the active module being edited. In version 3.00, the target type setting is
specific only to the active module being edited and saved within that module. The
toolbar buttons reflect the target type of the active module within the SIMPL+
environment.
One or both targets may be selected to compile the program for both types of control
systems. When compiling a program for a specific type of control system, an error
message appears if a wrong control system target is selected that does not support a
particular function or syntax.. Shown below are the two target selection buttons of the
menu toolbar.
Toolbar Target Selection Buttons.
X-GEN - shortcut to Build | X-Generation Control Systems Target 2 - shortcut to
Build | 2-Series Control Systems Target. (This is the default setting upon opening
SIMPL+.)
NOTE: If a program is compiled for the wrong type of control system, an error
message appears when attempting to upload, and the program must be recompiled.

Edit Preferences

Preferences Toolbar Pull-Down Menu
Software
®
SIMPL+ 9