Table of Contents
Advertisement
Adjusting the picture
VIDEO
Picture Mode
Contrast
Brightness
Color
Sharpness
Hue
Advanced
Move
Enter
VIDEO
Picture Mode
Contrast
Brightness
Color
Sharpness
Hue
Advanced
Move
OK
VIDEO
Picture Mode
Contrast
Brightness
Color
Sharpness
Hue
Advanced
Move
Enter
VIDEO
Color Temp
Noise Reduction
Display Mode
Over Scan
Move
Enter
Freezing the picture
Adjusting the Picture
To adjust the picture:
1
Press MENU. The on-screen menu opens with the VIDEO menu
displayed, then press ENTER to access.
2
Press 6
User
49
option; If a sub-menu exits, press ENTER to access the option, then
49
press 3
62
select:
49
Picture Mode — Selects the picture mode. You can select:
61
!
. Vivid (a bright and vivid picture)
. Standard (a standard picture)
Return
. Gentle (a soft picture)
. User (user customized picture).
Note: You can also press PICTURE on the remote control to select
User
Vivid
the picture mode.
50
Standard
50
Contrast — Adjusts the contrast.
Gentle
!
60
User
Brightness — Adjusts the brightness.
!
49
Color — Adjusts the color saturation.
61
!
Sharpness — Adjusts the sharpness.
!
Hue — Adjusts the image tint(only for NTSC system).
!
Return
3
To adjust advanced video settings, in VIDEO menu press 6
highlight Advanced, press ENTER to access the sub-menu.
4
Press 6
User
option. Press 6
49
confirm, or press 3
49
62
Color Temp — Selects the color temperature. You can select
!
49
Warm (to enhance the reds), Cool (to enhance the blues), or
61
Normal.
Noise Reduction — Selects the noise reduction mode to reduce
!
picture noise (snow). You can select Low, Middle, High, or OFF.
Return
Display Mode — Selects the aspect ratio of the picture. You can
!
select:
. 4:3 — Shows picture in 4:3 display mode.
Normal
. 16:9 — Shows a full-screen picture in 16:9 mode.
Middle
16:9
. Zoom1 — Enlarges the picture vertically. The top and bottom
ON
may be cropped.
. Zoom2 — Enlarges the picture both horizontally and vertically.
The edges may be cropped.
. Panorama — Stretches the picture at the edges, but maintains a
Return
good aspect ratio at the center of the screen.
Note: You can also press ZOOM on the remote control repeatedly
to select the display mode.
Over Scan — Turns this ON to adjust the picture's reproduction
!
rate when receiving HDMI signal in VIDEO format.(Depending on
versions, in some model this function is not available)
5
To close the menu, press EXIT button.
To freeze the picture:
Press the FREEZE button to freeze the image on the screen (the video
sources still run). Press again to restore.
Note:
! If a fixed image is displayed on the screen for a long time, that fixed
image may become imprinted on the screen and remain visible.
Therefore do not freeze the picture for a long time.
! In some mode, the FREEZE function can not work.
or 5
to highlight an option, press 3
4
6
5
to operate and press ENTER to confirm. You can
or 5
to highlight an option, press ENTER to access the
or 5
to select the setting and press ENTER to
or4
to adjust the option. You can select:
16
or4
to adjust the
or 5
to
Advertisement
Table of Contents
