Table of Contents
Advertisement
Memorizing the Channels & Setting the Channels
When you turn on the TV for the first time, you should perform an auto channel scan to set up stations on your TV.
Note: Be sure to select the TV input source before operation.
Setting the AIR/CABLE option
CHANNEL
AIR/CABLE
MTS
Color System
Auto Scan
Channel Edit
Move
OK
Auto Channel Scan
CHANNEL
AIR/CABLE
MTS
Color System
Auto Scan
Channel Edit
Move
Enter
Channel Scan
Total Channel
4
96.75MHz
Exit
Auto/Manual fine tuning
CHANNEL
AIR/CABLE
MTS
Color System
Auto Scan
Channel Edit
Move
Enter
CHANNEL
Skip Channel
FineTune
AFC
Fav CH
Move
Adjust
Before your TV can memorize the available channels, you must specify
the type of signal source that is connected to the unit. (i.e., an antenna or
cable system)
CABLE
To set the AIR/CABLE option:
AIR
MONO
CABLE
AUTO
1
Press MENU. The on-screen menu opens.
2
Press 6
3
Highlight AIR/CABLE, then press ENTER.
Return
4
Press 6
Select CABLE if using Cable TV, select AIR if using VHF/UHF antenna.
5
To exit, press EXIT button.
You should perform an auto channel scan to search for all channels
available and stores them in memory.
To auto scan for channels:
CABLE
MONO
1
Go to CHANNEL menu.
AUTO
2
Press 6
The TV begins scanning for available channels in your area and stores
them into memory. This may take several minutes, please wait.
Return
During the process, you may press EXIT to stop the auto scan, but
you will need to run the auto scan again to set up stations on your TV.
Fine Tuning is not necessary under normal conditions. However, in area
of inferior broadcast conditions where adjustment is necessary for a
better picture and sound, use fine tuning (auto or manual fine tuning) .
CABLE
To auto or manual fine tune the programs
MONO
1
Select a channel you want to perform fine tuning.
AUTO
2
Go to CHANNEL menu.
Press 6
3
Press 6
4
Return
fine tune until the best possible picture and sound are achieved.
5
Or you can turn AFC function to ON to automatically fine tune the
OFF
program.
0
In Channel Edit sub-menu, highlight AFC and press 4
OFF
to select ON and then press ENTER.
OFF
If you perform manual fine tuning, the AFC function will be turned off
automatically.
To return to previous menu, press MENU. To close the menu, press
6
Return
EXIT button.
or 5
to display CHANNEL menu, then press ENTER.
or 5
to select AIR or CABLE, then press ENTER.
or 5
to highlight Auto Scan, then press ENTER.
or 5
to highlight Channel Edit, then press ENTER.
or 5
to highlight FineTune, then use 3
14
or4
to manually
, use 6
or 5
Advertisement
Table of Contents
