Table of Contents
Advertisement
4. PAPER ROLL REPLACEMENT
Never insert paper roll if torn. Doing so will cause paper to jam.
Always cut leading edge with scissors first.
1. Insert the leading edge of the paper roll into the opening. (Fig.1)
2. Turn the power on and feed the paper by pressing
3. Insert the paper roll to the paper holder. (Fig.3)
Caution: Do not pull paper backwards as this may cause damage to
printing mechanism.
5. NOTES FOR SERVICING
(1) SL-SW BLINDER (4P/6P)
(6P)
It inserts so that it cuts,
and it may lack and a
part may come to the
Key Top side .
UPPER CASE
Fig.1
. (Fig.2)
Fig.2
Fig.3
(4P)
Key Top side .
SLIDE SW UNIT
SL-SW MASK (S)
SL-SW MASK (L)
EL-2631L/2615P PAPER ROLL REPLACEMENT
(2) PROTECTION TUBE
(2)-1. EL-2631L (ABC, ACO), EL-2615P
Insulate between the transformer and the AC cord connector with pro-
tection tubes (2 pcs x 2 positions).
Protection tube (2 pcs)
Protection
tube (2 pcs)
(2)-2. EL-2631L (TRC)
The EL-2631L (TRC) uses 14 protection tubes in total (that is, 2 pcs x 7
positions) as shown above.
[VOLTAGE SELECTOR]
Protection tube
(Heat contraction tube)
2 pcs/position
x
5 positions
[FUSE HOLDER]
Protection tube
(2 pcs)
Protection tube
(2 pcs)
– 3 –
Transformer
Protection tube
(One: Outside)
Protection tube
(One: Inside)
Use two protection tubes at
every one position.
Fuse
holder
Advertisement
Table of Contents
