Advertisement
10. MAXIMUM UPDATE TIME (Hi-Udt), (Seconds)
This is the maximum amount of time before the rate display goes to
zero. The rate display goes to zero if the time between successive pulses
exceeds the high update (Hi-Udt) time. The high update time ranges from
00.1 to 99.9 seconds.
11. FACTORY SETTINGS (FACt SEt)
All of the parameters are restored to the factory default settings
when YES is selected and the front panel select button is pressed. The
DP21 displays „LoAd‟ for several seconds and then returns to programming
of Factory Settings parameter. Factory settings for all the programmable
values are listed below.
dSPSEL
rSt En
tot dP
SCLFAC
rAtE En
rAtE dP
rAtE dSP
rAtE INP
Lo-Udt
Hi-Udt
12. ADDRESS (Addr)
Program the address of DP21.The address of DP21 can be
programmed from 00 to 99.
13. BAUD RATE (bAUd)
Program the communication baud rate of DP21.
Wisnu and Supak Co., Ltd 102/111-112 Tessabansongkroh Rd., Ladyao, Jatujak, Bangkok 10900
Tel (662)591-1916, (662)954-3280-1, Fax (662)580-4427, www.wisco.co.th, E-mail
YES
YES
0
01.0000
YES
0.00000
0.00001
01.0 (Hz)
01.0 (Seconds)
01.0 (Seconds)
WISCO DP21 Manual V1.1
Page 5 of 8
info@wisco.co.th
Advertisement
