Advertisement
Programming Mode
Programming or Normal Mode Selection
When power is applied to the DP21, it will be in Normal operating
mode. To change to the Programming Mode press the „Select‟ button and
hold it for 5 seconds. To change back to the normal Operating Mode just
do the same as Programming Mode.
Programming Description
Programming the DP21 is done with front panel buttons. Although
the unit has been programmed at the factory. The parameters generally
have to be changed to meet the user‟s requirements, to enter the
Programming Mode.
Pressing the select button scrolls through the menus. The display
alternately flashes between the menu and the currently selected data.
Pressing the „Reset‟ button stops the display from flashing and enters the
unit into Data Modification Mode.
In Data Modification Mode, a menu provides one of two types of
parameter to program.
1. Selection Type – The operator presses the reset button to
through the various parameter available for that menu or to toggle
between „YES‟ or „NO‟ selection. Pressing the „Select‟ button will exits from
Data Modification Mode and advances to the next menu.
2. Numerical Type – The „Reset‟ button increments the numerical
value of the flashing digit. Momentarily pressing the „Select‟ button
advances to the next digit. To advance to the next menu first press the
„Select‟ button and without releasing it press the „Reset‟ button.
All parameter value are saved when exiting the programming mode.
To exit from Programming Mode press „Select‟ button and hold for 5
seconds.
Page 2 of 8
บริ ษ ั ท วิ ศ ณุ แ ละสุ ภ ั ค จ ากั ด 102/111-112 หมู ่ บ ้ า นสิ น พั ฒ นาธานี ถนนเทศบาลสงเคราะห์ แขวงลาดยาว เขตจตุ จ ั ก ร กรุ ง เทพฯ 10900
โทร. (02)591-1916, (02)954-3280-1, แฟกซ์ (02)580-4427
WISCO DP21 Manual V1.1
, www.wisco.co.th,
อี เ มล์
info@wisco.co.th
Advertisement
