Advertisement
Programming Menus
1. SECLECT ENABLE (dSPSEL)
The front panel Select button can be enabled (Yes) OR disabled (No)
during normal operation. If „No‟ is selected, the display remains either on
the rate or counter display(s) depending on which was viewed when
programming was entered.
2. RESET ENABLE (rSt Enb)
The front panel Reset button can be enabled (Yes) or disabled (No)
during programming. The counter may not be reset via the front panel if
disabled.
3. COUNTER A DECIMAL POINT (tot dP)
There are six decimal point locations available for the count display.
The decimal point locations are used for the count display only and are
independent of the rate display.
0
0.0
0.00
0.000
0.0000
0.00000
0.000000
4. COUNTER A SCALE FACOTR (SCLFAC)
The scale factor is prescaler, therefore changing the scale value
does not change the existing internal count, and only effects the incoming
pulse count. The count scale factor Value can range from 0.0001 to
99.9999.
Wisnu and Supak Co., Ltd 102/111-112 Tessabansongkroh Rd., Ladyao, Jatujak, Bangkok 10900
Tel (662)591-1916, (662)954-3280-1, Fax (662)580-4427, www.wisco.co.th, E-mail
WISCO DP21 Manual V1.1
Page 3 of 8
info@wisco.co.th
Advertisement
