Advertisement
5. RATE ENABLE (rAtE Enb)
Selecting "Yes" enables the rate indicator function. If disabled (No),
the rate programming steps will not appear. This affects the rate only.
Note: the precision of a counter application cannot be improved by
using a scale factor greater than one. To accomplish greater precision,
more pulse information must be generated per measuring unit.
6. RATE DECIMALPOINT (rAtE dP)
Select the desired decimal point position for the rate display,
independent of the count display.
0
0.0
0.00
0.000
0.0000
0.00000
7. RATE DISPLAY (rAtE dSP)
Program the desired rate display value which corresponds to the
programmed rate input (rate INP) value. The rate display value can be
programmed from 000001 to 999999.
8. RATE INPUT (rAtE INP), (Hz)
Program the rate input value that should correspond to the rate
display (rAtE dSP) value. The rate input value can be programmed from
00000.1 to 99999.9 and should correspond to the signal input frequency.
9. MINIMUM UPDATE TIME (Lo-Udt), (Seconds)
This is the minimum amount of the time between display updates
for the rate display. This affects the rate display only. The low update time
ranges from 00.1 to 99.9 seconds. To assist in stabilizing an erratic
display, increase Lo-Udt for a display averaging effect.
Page 4 of 8
บริ ษ ั ท วิ ศ ณุ แ ละสุ ภ ั ค จ ากั ด 102/111-112 หมู ่ บ ้ า นสิ น พั ฒ นาธานี ถนนเทศบาลสงเคราะห์ แขวงลาดยาว เขตจตุ จ ั ก ร กรุ ง เทพฯ 10900
โทร. (02)591-1916, (02)954-3280-1, แฟกซ์ (02)580-4427
WISCO DP21 Manual V1.1
, www.wisco.co.th,
อี เ มล์
info@wisco.co.th
Advertisement
