Specifications - Sears Craftsman CTX 9000 Operator's Manual

ENGINE
Briggs & Stratton
Make Briggs & Stratton®
Model Professional Series
Horsepower 20 Gross HP @ 3400 +/- 100 rpm
Displacement 40.0 cu in. (656 cc)
Electrical System Alternator: 9 amp DC Reg.
Battery: 12 volt, 230 CCA
Die Hard Gold #50784
Oil Capacity 64 oz (1,9 L)
CHASSIS
Fuel Tank Capacity 3.5 Gallons (13,2 L)
Front Wheels Tire Size: 15 x 6.0-6
Rear Wheels Tire Size: 22 x 9.5-12
Power Rating
The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive
Engineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained
and corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower
values are derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.COM. Net
power values are taken with exhaust and air cleaner installed whereas gross power values are collected without these
attachments. Actual gross engine power will be higher than net engine power and is aff ected by, among other things,
ambient operating conditions and engine-to-engine variability. Given the wide array of products on which engines
are placed, the gas engine may not develop the rated gross power when used in a given piece of power equipment.
This diff erence is due to a variety of factors including, but not limited to, the variety of engine components (air cleaner,
exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (tempera-
ture, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs & Strat-
ton may substitute an engine of higher rated power for this Series engine.
Parts and Accessories
Contact an authorized dealer for parts and accessories.
30

SPECIFICATIONS

TRANSMISSION
Type
Hydraulic Fluid
Speeds
TM
@ 3400 rpm
Continuous Torque
Output
MOWER
Width of Cut
Number of Blades
Base Deck Platform
Cutting Height
Cutting Positions
DIMENSIONS
Overall Length
Overall Width
Height
Hydrostatic Tuff Torq K46
10w 30 Premium Engine Oil
Forward: 0-5.8 MPH (0-9,3 km/h)
Reverse: 0-3.5 MPH (0-5,6 km/h)
170 ft-lbs (230 Nm)
42" (106,7 cm)
2
Side Discharge
1.5 - 4.0 in. (3,8 - 10,2 cm)
Infinite
71" (180,3 cm)
52" (132,1 cm)
45" (114,3 cm)