Whirlpool W7 OM5 4 H Quick Manual page 11

REMOVING AND REFITTING THE DOOR
1. To remove the door, open it fully and lower the
catches until they are in the unlock position.
a
b
2. Close the door as much as you can. Take a firm
hold of the door with both hands – do not hold it
by the handle.
Simply remove the door by continuing to close it
while pulling it upwards at the same time until it is
released from its seating. Put the door to one side,
resting it on a soft surface.
~15°
b
a
3. Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
4. Lower the door and then open it fully. Lower the
catches into their original position: Make sure that
you lower them down completely.
a
b
Apply gentle pressure to check that the catches
are in the correct position.
"CLICK"
5. Try closing the door and check to make sure that
it lines up with the control panel. If it does not,
repeat the steps above: The door could become
damaged if it does not work properly.
EN
11