Various Settings; Setting Thickness - Panasonic YD-400VP1YHD Operating Instructions Manual

8. Various settings

8. Various settings

8.1 Setting THICKNESS

A function that selects a guideline welding condi-
tions (current and voltage for main welding) by
specifying the thickness of workpieces to be
welded.
About guideline welding conditions (welding current and voltage) the THICKNESS settings func-
Note
tion automatically selects
• With THICKNESS settings, it is possible to set
welding conditions for the initial welding and
crater welding, however, those set values
need to be adjusted according to the welding
conditions for main welding.
• Values automatically obtained by THICKNESS
settings are not guaranteed values. They are
indications obtained through the use of
brand-new parts under the environment of
our testing station.
• Use them as indications. Fine-tune them to
suit for your workpiece.
1． Select a material, wire diameter, gas, control process and pulse.
① Specify a material, wire diameter and
gas. (See section "7.1.2 Specifying
welding conditions (material/wire
diameter/gas and pulse)" on page 63.)
For wire diameter and thickness, see
the next page.)
② Specify a control process.
(See section "7.1.3 Specifying
CONTROL process" on page 66.)
74
• The standard settings are recommendation
values for the case of fillet welding (joint
type) at 0.3 m/min (welding speed). The leg
length becomes 70 % when the thickness is
12 mm. The thinner the workpiece is the
larger the leg length becomes. And the
thicker the workpiece is, the smaller the leg
length becomes.
• It is possible to adjust the recommended
welding speed (see section "8.7 Group 4:
CUSTOMIZATION settings" on page 114.)
Output/Settings
Display1
Display1
select button
Dial1
Panasonic
VP1 series
WELD
WELD
NAVI.
DETAIL
CALL
RECORD
SELECT
mode SELECT button
WMD078TE0PAA07