Welding Condition Recording Sheet - Panasonic YD-400VP1YHD Operating Instructions Manual

14. Welding condition recording sheet

• It is recommended to keep a note of the user-
created welding conditions for your
convenience.
• Those user-create welding conditions can be
saved in this unit by allocating a channel
number to each of them.
• Copy and use the following "Channel list" to
register the saved set contents.
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Channel (CH) number
WELDING CONDITIONS
INITIAL
Current
Voltage
( ±) ･ (V)
ADVANCED settings (Functions)
Item
00 (RUN-IN SPEED)
01 (HOT VOLTAGE)
02 (FTT LEVEL)
03 (BURNBACK TIME)
04 (PENETRATION)
05 (PRE-FLOW TIME)
06 (POST-FLOW TIME)
07 (PULSE PEAK CUR.)
08 (PULSE BASE CUR.)
09 (PULSE RISE CUR.)
10 (PULSE FALL CUR.)
11 (WFS FINE ADJ)
13 (WAVE CONTROL 1)
CONTROL settings
Item
• CRATER
CONTROL
• INI.&CRATER
TYPE
• ARC SPOT
WMD078TE0PAA07
Material to be welded
WELD
(A) (A)
(±) ･ (V)
Settings
Settings
OFF/ON
OFF/ON
14. Welding condition recording sheet
• For welding conditions and channel number,
see section "8.9 CALL" on page 120, and "8.8
RECORD" on page 117.
• For Advanced (welding) parameters, see
section "8.3 DETAIL" on page 82.
Remarks
CRATER SPOT TIME
(A)
( ±) ･ (V)
Item
14 (PULSE FREQ.)
17 (PULSE WIDTH)
18 (CRATER DC)
19 (INIT PLS DC)
20 (LOW PULSE SET)
21 (LOW PULSE CUR)
22 (LOW PULSE VOL.)
23 (LOW PULSE FREQ.)
24 (LOW PULSE DUTY)
25 (LOW PULSE DELAY)
30 (DISPLAY TIME)
32 (PENET INC.)
MATERIAL/WIRE DIA./GAS settings
MATERIAL
MS-SOLID
MS-FCW
SUS
SUS-FCW
AL-HARD
AL-SOFT
Prepared on Prepared by
WAVEFORM
CONTROL
(s)
Settings
WIRE DIA.
GAS
(mm)
0.8
CO
2
0.9
MAG
1.0
MIG
1.2
PULSE MAG
1.4
PULSE MIG
1.6
151