Peripheral And Optional Equipment (Sold Separately); Wire Feeder; Welding Torch - Panasonic YD-400VP1YHD Operating Instructions Manual

4.2 Peripheral and optional
equipment (sold separately)

4.2.1 Wire feeder

Model number
Drive method
Applicable wired dia.
(mm)
Spool shaft
To use a wire diameter other than the applicable one, an optional part (sold separately) is needed.

4.2.2 Welding torch

Model number
Rated current
Applicable wire type
Applicable wire dia.
(mm)
Cable length
Cooling method
CO
2
MAG
Duty
cycle
MIG
(%)
Pulsed MAG
Pulsed MIG
WMD078TE0PAA07
Mild steel/Stainless steel (Air-cooled)
YW-40DG2YAD
Two drive rolls
1.0, 1.2
With brake
Mild steel/Stainless steel (Air-cooled)
YT-35ESG4
350 A
Mild steel/
(Stainless steel)
1.2
3 m
Air-cooled
300 A: 60 %,
350 A: 45 %
350 A: 35 %
(350 A: 35 %)
350 A: 20 %
(350 A: 10 %)
• To apply a welding process or wire type indicated in brackets (), an optional
part (sold separately) is needed. If the optional part is not used, the torch
wears significantly.
• To use a wire diameter other than the applicable one, an optional part (sold
separately) is needed.
• Use of a wire other than the specified diameter or an elongated wire (over 3
m) can cause trouble in wire feed performance as a result, arc becomes unsta-
ble.
• To use a water cooled welding torch, the water coolant and the water cooling
hose unit are needed (sold separately).
4. Configuration
Aluminum (Water-cooled)
YW-40DGW2YAE
Four drive rolls
1.2, 1.6
With brake
Aluminum (Water-cooled)
YT-50MFW2
500 A
Aluminum/
(Mild steel/Stainless steel)
1.6
3 m
Water-cooled
(500 A: 100 %)
(450 A: 100 %,
500 A: 80 %)
450 A: 100 %,
500 A: 80 %
(500 A: 60 %)
500 A : 60 %
17