Table of Contents
Advertisement
14
Enabling the Cache (OS/2 version)
The OS/2 2.0 or higher cache control program, SLCOS220.SYS, should be loaded as a device driver in your
CONFIG.SYS file. To add the device driver to your CONFIG.SYS file, do the following:
Step 1. Copy SLCOS220.SYS to the OS/2 root directory on the hard drive, or to a bootable floppy if
you are booting from a floppy.
Step 2. Using your favorite text editor, add the following line as the last "DEVICE=" line in your
CONFIG.SYS file:
DEVICE = C:\OS2\SLCOS220.SYS
This will enable the SLC/Now! to operate at optimum performance. Please note, you cannot open a DOS
window within OS/2 to run the speed test from the Kingston diskette. To test the SLC/Now!'s performance
you must boot from a DOS floppy to run the Landmark 2.0 speed test.
Troubleshooting
This troubleshooting section and Appendix C "Common Problems" listed in the back of this manual are
designed to assist you in correcting problems with your system. If you do not find your problem listed, or the
suggestions described do not solve your problem, call Kingston Technical Support at (714) 435-2639. Please
have available the following information before you call:
·
Speed rating of the math coprocessor if installed.
·
Exact wording of any error messages associated with the problem.
·
Listing of your CONFIG.SYS.
·
Listing of your AUTOEXEC.BAT.
·
Version number of your application/operating system.
Machine Does Not Boot
1. Check that all power and cables are plugged into the right locations. The system unit power indicator
and Display indicators should show light indicating power.
2. Turn off the computer and unplug the unit from the power outlet. Remove the cover from the system
unit and check that all adapter boards are firmly seated in their sockets. Replace the cover and turn
the power on again.
3. Turn off the computer and unplug the unit from the power outlet. Check the orientation of Pin 1.
Make sure Pin 1 on the 80286 socket matches Pin 1 on the SLC/Now! and insure that it is firmly
seated in the 80286 socket.
SLC/Now! Installation Guide - Rev. D1
Troubleshooting
Kingston Technology Corporation
Advertisement
Table of Contents
