Mitsubishi Electric D700 Quick Start Manual page 12

D700 QUICK START MANUAL
n CHANGING THE PARAMETER SETTING VALUE
Change the Pr. 1 Maximum frequency setting.
O p r e t a o i n
1.
Screen at powering on
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Press to choose the parameter setting
mode.
4.
Turn until (Pr. 1) appears.
5.
Press to read the present set value.
" "(120.0Hz (initial value)) appears.
6.
Turn to change the set value to
" " (60.00Hz).
7.
Press to set.
Turn to read another parameter.
Press to show the setting again.
Press twice to show the next parameter.
Press twice to return to frequency monitor.
NOTES
to is displayed ... Why?
Write disable error
„ „
Write error during operation
„ „
Calibration error
„ „
Mode designation error
„ „
The number of digits displayed on the operation panel is four. Only the
upper four digits of values can be displayed and set. If the values to be
displayed have five digits or more including decimal places, the fifth or
later numerals can not be displayed nor set.
(Example) For Pr. 1
When 60Hz is set, 60.00 is displayed.
When 120Hz is set, 120.0 is displayed and second decimal place is not
displayed nor set.
n SETTING DIAL PUSH
Push the setting dial to display the set frequency* currently set.
* Appears when PU operation mode or external/PU combined
operation mode 1 is selected (Pr. 79 = "3").
12
MitsubishiElectric Automation, Inc.
D s i p a l y
PU indication is lit.
PRM indication is lit.
(The parameter number read previously
appears.)
Flicker...Parameter setting complete!!