U-Line H-7767 Instruction Manual

π
H-7767, H-7768
DEPOSITORY SAFE
TOOLS NEEDED
Adjustable Wrench
Drill
GETTING STARTED
NOTE: Keep door open during setup.
1. Turn the keypad housing counter clockwise and
carefully pull away from the mounting plate to
expose battery compartment.
2. Install four new AAA Alkaline batteries. Hold onto the
keypad housing to avoid pulling wires.
3. Carefully position the keypad into the inserts on the
mounting plate and turn clockwise. Ensure that there
are no wires or cables trapped between the keypad
and the mounting plate. Pinched cables result in a
short circuit.
4. Enter: * - Master or Manager Code (from front of
booklet) - # The lock will indicate a valid code
entry with a single signal and the open light will stay
green for five seconds.
5. Turn the handle clockwise before the green light
disappears.
ENTERING YOUR SECURITY CODE
NOTE: A single signal (LED flashes and beeps
once) response from the lock indicates valid
entry. A double signal (LED flashes and beeps
twice) response from the lock indicates an
invalid entry.
NOTE: If three incorrect entries are entered in
a row, the keypad will shut down for a period
of five minutes. During this shut down period,
keypad will be unresponsive.
CHANGING THE MASTER CODE
NOTE: Master Code is a 1 to 10 digit code.
Always perform this operation with the door
open.
PAGE 1 OF 9
1-800-295-5510
uline.com
HARDWARE INCLUDED
Masonry Anchor x 4
USAGE
1. Enter: # - Existing Master Code - #
2. The set light will stay orange for ten seconds.
3. Enter: 1 - * - New Master Code - # - New Master
Code - #, before the orange light disappears.
4. Test new code several times before closing the door:
Enter: * - Code - #
CHANGING THE MANAGER CODE
1. Enter: # - Master Code or Manager Code - #
2. The set light will stay orange for ten seconds.
3. Enter: 2 - * - New Manager Code - # - New Manager
Code - #, before the orange light disappears.
4. Test new code several times before closing the door:
Enter: * - Code - #
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
NOTE: If a mistake is made during the change,
wait 30 seconds to repeat steps 1 through 3.
NOTE: The lock will indicate a valid code
change with a single signal.
NOTE: The lock will indicate an invalid code
change with a double signal and the old code
is still valid.
NOTE: Manager Code is a 1 to 10 digit code.
Always perform this operation with the door
open.
NOTE: If a mistake is made during the change,
wait 30 seconds to repeat steps 1 through 3.
NOTE: The lock will indicate a valid code
change with a single signal.
NOTE: The lock will indicate an invalid code
change with a double signal and the old code
is still valid.
0521 IH-7767