Part 2: Installation; Part 3: How To Use - Modena Salutare Series User Manual Book

Please read this manual carefully before operating the unit for proper and safe usage. Examine the
entire sign or warning listed on the pictures or written explanation.
1. Install the dispenser on a flat and stable surface. Provide a
minimum of 20 cm distance from the wall.
2. Leave it for 1 hour to stabilize the refrigerant.
3. Insert the pipe into the gallon and then place the cover into the
mouth of the gallon.
4. Place the gallon inside the cabinet and close the lower cabinet
door.
5. Connect the electrical cord to the power socket, and turn on the
red switch (heater) located behind the unit. Ensure that the
socket/electric source has a grounding to prevent electric
leakage. Then, turn on the switch located behind the unit.
6. For first time usage, the inside of the unit must be cleaned.
Press the hot water and cold water button. Make sure the
water comes out from both taps. After the water comes out
from both taps, wait for 20 minutes, then remove the gallon
from the cabinet storage and empty the water in the unit by
opening the drain cover. Make sure the power cord is
unplugged from the power socket when draining the water.
Attention :
-
This unit is designed for indoor use.
-
Make sure the pipes are installed properly and the cabinet door is
tightly closed.
-
When the water in the gallon is empty, turn off the red switch (heating) before replacing it with a
new one.
-
Avoid placing the appliance in a humid, wet, and poor electrical installation because it may cause
an electric shock or fire outbreaks.
-
Do not place flammable objects near the dispenser.
-
Do not put the appliance in direct sunlight and rain because it can degrade the performance and
cause an electrical leakage hazard.
-
Do not connect this dispenser to electric source or pressing the heater if there is no water in the
tank or no water flows from the hot water tap when the button is pressed.
-
Do not modify the power cord of the unit or connect using an extension of electricity to prevent a
short circuit and fire hazard.
-
Do not touch the back of the condenser to avoid shocks.
How to use a dispenser with three taps:
-
To dispense hot water, push the left button / tap.
-
To dispense normal-temperature water, push the central button / tap.
-
To dispense cold water, push the right button / tap.
This unit features a safety on hot water button to keep hazards out of the reach of children. Scroll and
press the button to dispense hot water.
Part 2:
Installation
Part 3:
How to Use
4