Advertisement
C
SETUP SCREENBEAM FOR NETWORK CONNECTION
ScreenBeam receiver requires network connection for couple various functionalities; Wireless display
over LAN and Central Management. You can connect the ScreenBeam receiver to the network via either
wired or Wi-Fi connection.
•
Wired connection
If the network connection for ScreenBeam receiver provides a DHCP IP address, the Ready to
Connect screen shall display a valid IP address under network status.
•
Wi-Fi connection or Static IP address
This requires additional steps to configure the receiver with the proper network information. The
detailed instructions can be found online at http://support.screenbeam.com. For initial testing
purpose, we recommend using wired network connection with DHCP.
D
ACCESS SCREENBEAM RECEIVER FOR CONFIGURATION
You can configure ScreenBeam 1100 receiver by accessing the receiver web management console or by
using the ScreenBeam CMS software. If the ScreenBeam receiver is being managed by ScreenBeam CMS,
then you may skip this section.
There are a couple of options to access the ScreenBeam receiver's management console:
•
Option 1 - Access the receiver via local network
o Verify the ScreenBeam receiver has obtained a valid IP address if it's connected to the
network.
o Connect a laptop or PC to the same network as the ScreenBeam receiver
o Open a browser and enter the IP address of the ScreenBeam receiver into the browser's
address text box (i.e. http://x.x.x.x)
o Refer to Log into the Management Console
•
Option 2 - Access the receiver via a Wi-Fi Miracast P2P connection
o On your Windows 10/8.1 device with Miracast
o Use Connect (Win10) or Charm (Win8.1) to connect to the ScreenBeam receiver
o Once connected, enter the following URL into the browser's address text box:
http://192.168.16.1
o Refer to Log into the Management Console
•
Log into the Management Console
o You may encounter a browser error that states "There's a problem with the wireless
security certification." Manually accept the connection by doing one of the following:
§
§
o When the ScreenBeam management console page appears, enter the following:
§
§
o Click Login.
o The ScreenBeam receiver management webpage should display.
http://support.screenbeam.com
For Chrome browser: click Advance, then click Proceed.
For Edge/IE browser: click Continue to this webpage (not recommended).
Username: Administrator
Password: Actiontec
Copyright © 2018 Actiontec Electronics, Inc.
Version 1.1
|
http://support.screenbeam.com/ticket
Advertisement
